Problem:
Error message „Magnet belt not down” displayed on HMI (magnet belt does only exist on the 2. table on a duplex slitter), and arrow buttons „Up” and „Down” for magnet belt are not visible anymore.
Possible Causes & Resolutions:
Arrow buttons magnet belt up may be visible for a short time and pushed during start up of panel.
Delete of error message:
- Login with canman user => Contact CANMAN for password
- Go to Setup
- Change the function Single slitter to OFF (See attached picture)
- Go back to main screen. Now the up and down button for magnet belt will be visible.
- Push and hold the arrow button down for magnet belt until the error message “Magnet belt not down“ disappears.
- Go back to the canman settings and set the function “Single slitter” back to ON.
![](https://www.canman.ch/wp-content/uploads/2021/03/faq-CM33-single-magnet-belt-not-down-1.jpg)
![](https://www.canman.ch/wp-content/uploads/2021/03/faq-CM33-single-magnet-belt-not-down-2.jpg)