Powder falling off, while the canbody is moving through PowerCURE™

Possible cause:

• Check whether the powder already was falling off, before the canbodies did enter into the PowerCURE™.
• The transport belts are not running steadily:
  • Check whether the belt from the motor to gearboxes is jumping over.
  • Do not tension too much, tension till the belt is not jumping over anymore.
• Take off the belt from motor and both transport belts, and check the play of both gear boxes:
  • The internal worm gear might be broken.
• Grease the guides of the transport belts to reduce the friction.
• Check whether the transport belts are moving straight into the guides:
  • The belt is possible touching left or right of the groove.
• Check all wheels and replace the bearing when not turning smoothly.
• Increase the transport belt speed.
  • Please check the curing after increasing the speed as this might require a bit higher voltage adjustment, however the consumed energy is the same.
• Check whether any screw from the frame or any of the feet has become loose.
• Check, if the motor/gearbox of the conveyor drive is grounded. Only applicable for latest model.
  • If not, ground the motor/gearbox.