Change to food-grade cooling emulsion

Empty the water tank. On 2-circuit cooling unit only cold water tank has to be emptied.
Blow off one by one each cooling circuit in the welder. This allows to empty each circuit separately. If your welder has a 2-circuit cooling system only the circuit for the lower and upper weld roll has to be emptied.
Change the filter cartridge and clean the filter housing inside.
Fill the tank with water only, open main valve Y14, and run the system for at least one hour to flush rests of old emulsion out.
Empty the water tank again and clean again if necessary.
Fill the water tank with water (or distilled water if requested), and mix the PowerRoll™ coolant H1 in with 8 percent.

We recommend following maintenance procedures:

Change the filter cartridge monthly.
Change the cooling emulsion yearly. Use the PowerRoll™ cooling system cleaner at any time you change the emulsion.
Use the PowerRoll™ cooling system decalcer after around 5 years.

Order numbers:

Safety data sheets see below:

Back