Check condition of synthetic roller. Ensure that application surface is smooth and does not show any defects > replace if required.
Measure velocity of overhead conveyor at welder exit for reference purposes. Set speed of outside lacquering unit equal to conveyor or alternatively, set it slightly higher (2–3% above effective conveyor speed)
> verify speed setting by measuring exact velocity, picking up speed of application surface at synthetic roller.
Apply slightly more lacquer on outer side seam. Please follow therefor point 7.2 (Adjustment of the lacquer quantity) in the provided instruction manual for the ORC.
As a last precaution, check the viscosity of your lacquer by using the DIN 4 cup supplied. Recommended viscosity: 20–25 seconds. Depending on type of lacquer used, add corresponding thinner / water in order to achieve required viscosity.
